15.1 PLC Connection 15-17
AFP7CCS1M1
Calendar
This model is equipped with a calendar function; however, the calendar data cannot be written from the V series. Thus, time
correction must be performed on the PLC side.
Available Device Memory
The available setting range of device memory varies depending on the PLC model. Be sure to set within the range available for
the PLC to be used. Use [TYPE] when assigning indirect device memory for macro programs.
*1 Specify the program block number. Indications on the screen configuration software are as follows.
*2 Specify the slot number. Indications on the screen configuration software are as follows.
Setting Item Contents Remarks
RS-485
Terminating
resistance setting
ON at termination
OFF
ON
Device Memory TYPE Remarks
DT (data register) 00H *1
X (external input) 01H
WX as word device; X0 to X1F and X70 to X9F: read only
*1
Y (external output) 02H
WY as word device; Y0 to Y9, Y13, Y15 to Y1F, Y70 to Y9F: read only
*1
R (internal relay) 03H
WR as word device, including special relays
*1
L (link relay) 04H
WL as word device
*1
LD (link register) 05H *1
T (timer/contact) 09H
Read only
*1
C (counter/contact) 0AH
Read only
*1
P (pulse relay) 0BH
Read only
*1
E (error report relay) 0CH Read only
SD (system data) 0DH Read only
SR (system relay) 0EH WS as word device, read only
IN (direct input) 0FH
WI as word device, read only
*2
OT (direct output) 10H
WO as word device
*2
UM (unit memory) 11H *2
TS (timer/set value) 12H
Double-word
*1
TE (timer/elapsed value) 13H
Double-word
*1
CS (counter/set value) 14H
Double-word
*1
CE (counter/elapsed value) 15H
Double-word
*1
I (index register) 16H Double-word
To Next Page
Loading...