Fuji Electric Monitouch V9 Series - Page 382

15.1 PLC Connection 15-21
*1 Specify the program block number. Indications on the screen configuration software are as follows.
*2 Specify the slot number. Indications on the screen configuration software are as follows.
Indirect device memory designation
* Specify the expansion code as follows.
Example: 1: DT000100
Address number
Device type
Program block number
0: Global device
1 to 999: Local device
Example: 1: UM000100
Address number
Device type
Slot number: 1 to 99
15 87 54 0
n + 0 Model Device type
n + 1 Lower address No.
n + 2 Program block number
Higher address No.
n + 3 Expansion code * Bit designation
n + 4 00 Station number
15 9 8
Slot number
0: 0 to 15 bits (lower)
1: 16 to 31 bits (higher)