15.2 Temperature Controller/Servo/Inverter Connection 15-67
Available Device Memory
The available setting range of device memory varies depending on the model. Be sure to set within the range available for the
model to be used. Use [TYPE] when assigning indirect device memory for macro programs.
*1 Parameter values will be changed temporarily. When saving parameter changes to EEPROM, use the macro command PLC_CTL.
For more information on the command PLC_CTL, see page 15-68.
Indirect Device Memory Designation
* In the expansion code, set which word, higher or lower, is to be read when a double-word address is specified.
Device Memory TYPE Remarks
STS (status) 00H Read only
OPLSC (command pulse counter) 01H Double-word, read only
FPLSC (feedback pulse counter) 02H Double-word, read only
SPD (current speed) 03H Read only
TLQ (current torque command) 04H Read only
DEVIC (current deviation counter) 05H Double-word, read only
INS (input signal) 06H Double-word, read only
OUTS (output signal) 07H Double-word, read only
STDC (current speed/torque/counter) 08H Double-word, read only
SIO (status, input signal, output signal) 09H Double-word, read only
FBS (feedback scale) 0AH Read only
ABS (absolute encoder) 0BH Double-word, read only
FSPLS (feedback scale deviation/total pulses) 0CH Double-word, read only
IPM (parameter (individual)) 0DH * 1
CALM (current alarm data) 0EH Read only
IALM (alarm history (individual)) 0FH Read only
AALM (alarm history (all)) 10H Read only
IAPM (parameter/property (individual)) 11H Read only
PAPM (parameter/property (all)) 12H
Read only, except for parameter values (current values)
*1
15 8 7 0
n+0 Models (11 to 18) Device type
n+1 Address No.
n+2
Expansion code
*
Bit designation
n+3 00 Station number
To Next Page
Loading...