Fuji Electric SPH Series - 1-1 Performance and Function Specifications

1-1
Section 1 Specications
Item
Specication
Main unit with 14/24 points Main unit with 32/40/60 points
Control system
Stored program,
Cyclic scanning system (default task), xed cycle task, event task
I/O connection method Direct input/output (local bus)
I/O control system
Whole: Scan batch refresh system
Digital I/O: Task synchronized refresh system
CPU 16-bit processor
Memory types Program memory, data memory, temporary memory
Programming language
IL language, (Instruction List)
ST language (Structured Text)
LD language, (Ladder Diagram)
FBD language, (Function Block Diagram)
SFC language, (Sequential Function Chart) Adhere to IEC61131-3
Length of instructions Variable length (depending on language)
Instruction execution
speed
Sequence instruction Contact: mini. 0.30 µs, Coil: min. 0.33 µs
Applied instruction Timer: min. 10.06 µs, Counter: min. 7.51 µs
Program memory capacity (Note 2) 8192 steps 20480 steps
Program steps in a POU 8192 steps 16384 steps
Memory
(Note 1)
I/O memory (I/Q) 512 words
Standard memory (M) 4096 words 8192 words
Retain memory (M) 2048 words 4096 words
User FB instance memory 4096 words 8192 words
User FB instance memory
Initial value setting memory
4608 words 9216 words
System FB
instance
memory
5632 words 11264 words
Timer 256 points 512 points
Additional timer 0 point 0 point
Counter 256 points 512 points
Edge detection 1024 points 2048 points
Others 512 words 1024 words
System memory (M) 512 words
Special relay/register (non-retain) (M) 4096 words
Special relay/register (retain) (L) 4096 words
Temporary area 8192 words
Available basic data type (Note 3)
BOOL, INT, DINT, UINT, UDINT, REAL,TIME, DT, DATE, TOD, WORD,
DWORD
Data type nesting
One level
(array of arrays, structure of arrays, array of structures, structure of structures)
1-1 Performance Specications
Notes:
1) You can freely increase or decrease the area sizes of the standard memory, retain memory, user FB instance memory, and
system FB instance memory. The above table shows the default values.
2) The initial value setting area of the standard memory and retain memory is included.
3) Available data types depend on the instruction.