Fax Service Settings
217
Tools
5
Note • A G3 ID (fax number) can consist of not more than 20 digits, including 0 to 9, +, and space.
G3 Line 1 to 3 - Dial Type
Set the dial type.
îš„Tone
Tone dialing line.
îš„10pps
Pulse dialing line.
G3 Line 1 to 3 - Line Type
Set the line type.
îš„PSTN
Subscriber telephone line.
îš„PBX
Private branch exchange.
Internet Fax Control
You can configure the settings related to the Internet fax control.
Internet Fax Path
Set the Internet fax communication path.
îš„Via E-mail Server
Sends e-mail via an SMTP server.
îš„Direct (P2P)
Directly sends to the machine with the Internet Fax feature, without going through an SMTP
server.
You can specify the following two types of e-mail address for the Internet Fax feature:
z
Specifying a host name
@ must be followed by FQDN.
Example: local-part@device.domain.jp
z
Specifying an IP address
@ must be followed by an IP address with brackets.
Example: local-part@[129.249.123.1]
Profile for Broadcast Job
Set the default value for an Internet fax profile when performing an Internet fax broadcast
send.
A profile is specified to restrict attribute information such as image resolution and paper size
for transmissions between Internet Fax-enabled machines.
Important • The supported TIFF-file profiles vary depending on the destination Internet Fax-enabled
machine. Before specifying a profile, check the profile that the destination machine supports.
îš„TIFF-S
The Internet fax standard profile. For documents larger than A4, the size is automatically
reduced to A4 when transmission.
îš„TIFF-F
Select this profile when you specify [Superfine] for [Resolution] or when you send A3 or B4
documents.
To Next Page
Loading...
Need help?
General
