Changing the Paper Size
49
Paper and Other Media
2
4 Load and align the edge of the paper against
the left side of the tray, with the side to be
copied or printed on facing up.
Important • Do not load paper above the maximum fill
line ("MAX" in the right figure).
5 Push the tray in gently until it stops.
Important • When inserting the tray, push it gently.
Forcibly pushing the tray in may cause
machine malfunction.
Note • Affix the paper size label to the front of
the paper tray.
For more information on paper type settings, refer to "Changing the Paper Settings" (P.53).
Changing the Paper Size for Tray 3 (When Tandem Tray Module is
Installed)
The following describes how to change paper size in Tray 3 when the Tandem Tray
Module is installed.
1 Pull out Tray 3 until it stops.
Important • While the machine is processing a job, do not pull out the tray that is being used for the job.
• To prevent paper jams or erroneous detection of loaded paper in a tray by the machine, do
not add paper on top of any remaining paper in the tray.
2 Remove any paper loaded in the tray.
3 Pinch the paper guide and slide it to the
desired paper size.
4 Load and align the edge of the paper against
the left edge of the tray, with the side to be
copied or printed on facing down.
Important • Do not load paper above the maximum fill
line. It may cause paper jams or machine
malfunction.
5 While pinching the paper guide, lightly align
the edge to the edge of the paper.
CAUTION
Make sure to pull out the tray
slowly. When the tray is being
pulled out with force, the tray
may possibly hit your knees or
other parts of your body causing
injuries.
To Next Page
Loading...
Need help?
General
