Configuration of Scan to Home (ApeosPort Series Models Only)
327
Scanner Environment Settings
9
1) Select [Authentication/Security Settings].
2) Select [Authentication].
3) Select [Login Type].
4) Select [Login to Remote Accounts], and then select [Save].
5) Select [Close].
6) Select [Close] repeatedly until the [Tools] screen is displayed.
3 Configure a remote authentication server to use.
You can select from [Kerberos (Windows 2000)], [Kerberos (Solaris)], [LDAP], [SMB],
or [Authentication Agent].
For information on the remote authentication server settings, refer to "Authentication System Setup
(ApeosPort Series Models Only)" (P.184).
1) Select [System Settings].
2) Select [Connectivity & Network Setup].
3) Select [Remote Authentication/Directory Service].
4) Select [Authentication System Setup].
5) Select [Authentication System], and then select [Change Settings].
6) Select the remote authentication system to use, and then select [Save].
7) Select [Close].
Note • If an authentication setting is not configured on a remote authentication server selected,
configure settings under [Remote Authentication/Directory Service]. For [LDAP Server/
Directory Service Settings], a configuration is required regardless of a remote authentication
server selected.
- For information on Kerberos Server Settings, refer to "Kerberos Server Settings (ApeosPort
Series Models Only)" (P.184).
- For information on LDAP Server/Directory Service Settings, refer to "LDAP Server/Directory
Service Settings (ApeosPort Series Models Only)" (P.185).
- For information on SMB Server Settings, refer to "SMB Server Settings" (P.188).
4 Select [Close] repeatedly until the [Tools] screen is displayed.
5 Select [Close].
Note • Rebooting the machine may be required depending on the settings. When a message
displayed on the screen, follow the message and reboot the machine.
6 Print a configuration report to confirm that the SMB port is enabled and that TCP/IP is
set up correctly.
For information on how to print a configuration report, refer to "Print Reports" (P.95).
Step 4 Configuring Scan to Home
Configure the Scan to Home settings using CentreWare Internet Services.
1 Start CentreWare Internet Services.
For information on how to start CentreWare Internet Services, refer to "Starting CentreWare Internet
Services" (P.276).
2 Enable the feature of the Scan to Home.
1) Click the [Properties] tab.
2) Click [ ] on the left of
[Services].
To Next Page
Loading...
Need help?
General
