5 Tools
250
Tools
5
1 Select [On].
2 Enter the F code with the numeric keypad.
Note • The F code consists of "0" + folder
number. For example, if the folder
number is 123, the F code will be "0123".
3 Enter the password as required with the
numeric keypad, and then select [Save].
Note • You can enter up to 20 digits for the
password.
Relay Broadcast
Set the instruction given to a relay station, which is used when the machine is a base station
and the registered speed dial is a relay station for relay broadcast.
When selecting [On], set [Relay Station ID], [Print at Relay Station], and [Broadcast
Recipients].
1 Select [On].
2 Enter a 2-digit relay station ID with the
numeric keypad.
Note • The relay station ID is the address
number for the base station (the machine)
already registered on the relay station.
3 Select [Speed Dial 001<->099].
4 Enter a speed dial number of broadcast
destination (001 to 099) or group number (#01 to #09) registered on the relay station
with the numeric keypad, and then select [Add].
Note • If there are more than one broadcast destinations, repeat step 4.
5 To print a document also at the relay station, under select [On] for [Print at Relay
Station].
6 Select [Save].
Billing - Day Time, Billing - Night Time, Billing - Midnight
Set the connection time for one unit charge in each of the time bands (daytime/night/
midnight).
You can set a value from 0.1 to 255.9 seconds in 0.1 second increments.
This item is displayed when [Accounting] > [Accounting Type] is set to [Local Accounting] and [Fax/
Internet Fax Service] is set to [Enable Accounting] under [Auditron Mode]. For information on how to
enable the feature, refer to "Auditron Mode" (P.257).
The information registered can be confirmed by printing a Billing Data List. For information about how
to print, refer to "Billing Data List" (P.100).
1 Select one of [Billing - Day Time], [Billing - Night Time], and [Billing - Midnight].
2 Select [Billing].
3 Enter the time for one unit charge from 0.1 to
255.9 seconds in 0.1 second increments
with the numeric keypad.
4 Select [Save].
To Next Page
Loading...
Need help?
General
