EasyManuals Logo

Fuji Xerox ApeosPort-IV C5570 Administrator's Guide

Fuji Xerox ApeosPort-IV C5570
673 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #288 background imageLoading...
Page #288 background image
7 Printer Environment Settings
286
Printer Environment Settings
7
4 Configure the following settings if required.
z
Print Mode
Configure the printer language on the machine to that of the received data.
z
PJL
Enable this setting to accept a job with PJL commands.
The PJL commands are independent of any printer languages. A printer language
used in the data received next can be set independently of the current printer
language.
z
Auto Eject Time
Set the time that the data so far received by the machine is automatically printed
since data is no longer sent to the printer.
z
Adobe Communication Protocol
Set the protocol defining the communications method between PostScript printers
and a host.
z
Bi-directional Communication
Configure the parallel port for either half duplex transmission or full duplex
transmission.
Note • Adobe Communication Protocol can be configured when the Adobe PostScript 3 Kit
(optional) is installed.
• Do not change the default settings for normal use. You may, however, need to change some
settings depending on the operating system of your computer.
5 Select [Close] repeatedly until the [Tools] screen is displayed.
6 Select [Close].
Note • Rebooting the machine may be required depending on the settings. When a message
displayed on the screen, follow the message and reboot the machine.
7 Print a configuration report to confirm that the parallel port is enabled.
For information on how to print a configuration report, refer to "Print Reports" (P.95).
8 Turn off the computer to be connected to the machine.
9 Connect a parallel interface cable to the parallel interface on the computer.
For information on how to connect a parallel interface cable, refer to "Using the Parallel Interface"
(P.20).
10 Start the computer.
Step 3 Configuration on the Computer
The following describes the configuration procedures for the computer.
To print from the machine, you need to install a print driver on your computer.
For information on the supported operating systems, refer to "Supported Operating Systems" (P.284).
For information on the driver installation procedure, refer to the manual contained in the Driver CD Kit.

Table of Contents

Other manuals for Fuji Xerox ApeosPort-IV C5570

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fuji Xerox ApeosPort-IV C5570 and is the answer not in the manual?

Fuji Xerox ApeosPort-IV C5570 Specifications

General IconGeneral
Print Resolution1200 x 2400 dpi
Scan Resolution600 x 600 dpi
FunctionsPrint, Copy, Scan, Fax
Duplex PrintingYes
Fax Transmission Speed33.6 kbps
Operating System CompatibilityWindows, Mac OS, Linux
Print Speed55 ppm (color and monochrome)
Monthly Duty Cycle300, 000 pages
ConnectivityEthernet, USB
Paper SizeA3, A4, A5, B4, B5
Memory2 GB
Hard Disk Drive160 GB
Copy Speed55 cpm (black/white and color)

Related product manuals