EasyManuals Logo

Fuji Xerox ApeosPort-IV C5570 Administrator's Guide

Fuji Xerox ApeosPort-IV C5570
673 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #318 background imageLoading...
Page #318 background image
9 Scanner Environment Settings
316
Scanner Environment Settings
9
Configuration of Store to Folder
This section describes configuration procedures to use the Store to Folder service on
the machine.
The following shows the reference section for each procedure.
Step 1 Enabling Port and Setting up TCP/IP ............................................................................316
Step 2 Registering a Folder.......................................................................................................317
Step 3 Configuring a Computer ................................................................................................317
Step 1 Enabling Port and Setting up TCP/IP
Using Network Scanner Utility3 (Scan Driver and Stored File Manager 3), which
supports WebDAV protocol, and EasyOperator (application) provided by Fuji Xerox,
enable the WebDAV, SNMP, and SOAP ports and set up an IP address.
EasyOperator allows you to retrieve files stored in a folder of the machine without a
scan driver.
Note • You can configure the settings using CentreWare Internet Services. For information on how
to use CentreWare Internet Services, refer to "Configuring Machine Settings Using
CentreWare Internet Services" (P.277).
1 Display the [Tools] screen.
1) Press the <Log In/Out> button.
2) Enter the system administrator's user ID with the numeric keypad or the keyboard
displayed on the screen, and select [Enter].
When a passcode is required, select [Next] and enter the system administrator's
passcode, and select [Enter].
Note • The default user ID is "11111".
• The default passcode is "x-admin".
3) Select [Tools] on the [Services Home] screen.
2 Enable the port.
1) Select [Connectivity & Network Setup].
2) Select [Port Settings].
3) Select [SNMP], and then select [Change Settings].
4) Select [Port Status], and then select [Change Settings].
5) Select [Enabled], and then select [Save].
6) Select [Close].
7) Select [SOAP], and then select [Change Settings].
8) Select [Port Status], and then select [Change Settings].
9) Select [Enabled], and then select [Save].
10) Select [Close].
11) Select [WebDAV], and then select [Change Settings].
12) Select [Port Status], and then select [Change Settings].
13) Select [Enabled], and then select [Save].
14) Select [Close] repeatedly until the [Tools] screen is displayed.

Table of Contents

Other manuals for Fuji Xerox ApeosPort-IV C5570

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fuji Xerox ApeosPort-IV C5570 and is the answer not in the manual?

Fuji Xerox ApeosPort-IV C5570 Specifications

General IconGeneral
Print Resolution1200 x 2400 dpi
Scan Resolution600 x 600 dpi
FunctionsPrint, Copy, Scan, Fax
Duplex PrintingYes
Fax Transmission Speed33.6 kbps
Operating System CompatibilityWindows, Mac OS, Linux
Print Speed55 ppm (color and monochrome)
Monthly Duty Cycle300, 000 pages
ConnectivityEthernet, USB
Paper SizeA3, A4, A5, B4, B5
Memory2 GB
Hard Disk Drive160 GB
Copy Speed55 cpm (black/white and color)

Related product manuals