Fuji Xerox ApeosPort-IV C5570 Administrator's Guide

Replacing Consumables
77
Maintenance
3
Emptying the Punch Waste Container (for Finisher-C1 or Finisher-C1 with
Booklet Maker)
When the optional Finisher-C1 or the optional Finisher-C1 with Booklet Maker is
installed and the hole punch waste container becomes full, a message appears on the
touch screen. When the message appears, empty the hole punch waste container as
instructed.
Make sure to discard all paper chads when emptying the hole punch waste container.
Not doing so will cause the container to fill up before the message telling you to empty
the container appears again, and this can cause machine malfunction.
Important • Empty the hole punch waste container when the machine is on. If you empty the container
while the machine is off, the machine does not recognize that the container has been
emptied.
1 Make sure that the machine is not operating,
and open the finisher front cover.
2 Pull out the hole punch waste container R4.
3 Empty the container.
4 Insert the emptied hole punch waste
container into the finisher until it stops.

Fuji Xerox ApeosPort-IV C5570 Specifications

General

Print Resolution	1200 x 2400 dpi
Scan Resolution	600 x 600 dpi
Functions	Print, Copy, Scan, Fax
Duplex Printing	Yes
Fax Transmission Speed	33.6 kbps
Operating System Compatibility	Windows, Mac OS, Linux
Print Speed	55 ppm (color and monochrome)
Monthly Duty Cycle	300, 000 pages
Connectivity	Ethernet, USB
Paper Size	A3, A4, A5, B4, B5
Memory	2 GB
Hard Disk Drive	160 GB
Copy Speed	55 cpm (black/white and color)