5 Tools
242
Tools
5
îš„Name, Server, Save in, User Name, and Password
Select [Name], [Server], [Save in], [User Name], or [Password] to display an input screen.
The numbers of characters you can input are as follows:
z
Name: Up to 18 single-byte characters
z
Server: Up to 64 single-byte characters
z
Save in: Up to 128 single-byte characters
z
User Name: Up to 97 single-byte characters
z
Password: Up to 32 single-byte characters
Transfer via SMB (1), Transfer via SMB (2) (ApeosPort Series Models Only)
[Transfer via SMB (2)] will be displayed when [Transfer via SMB (1)] is configured.
Specify where SMB forwarding is to be stored.
îš„Address Book
When the server address is registered on the Address Book, you can specify the address
from the Address Book. The specified address appears in the [Transfer via SMB (1)] or
[Transfer via SMB (2)] screen.
For more information on the Address Book, refer to "Add Address Book Entry" (P.244).
îš„File Format
Specify an output file format.
For more information on the [File Format] screen, refer to "5 Scan" in the User Guide.
îš„Resend Attempts
Set whether or not to try sending again if a transmission fails. If you select [On], set the
number of resend attempts and interval.
z
Resend Attempts
Set the transmission retry count from 1 to 5.
z
Resend Interval
Set the transmission retry interval from 30 to 300 seconds.
îš„Name, Server, Shared Name, Save in, User Name, and Password
Select [Name], [Server], [Shared Name], [Save in], [User Name], or [Password] to display an
input screen.
The numbers of characters you can input are as follows:
z
Name: Up to 18 single-byte characters
z
Server: Up to 64 single-byte characters
z
Shared Name: Up to 64 single-byte characters
z
Save in: Up to 128 single-byte characters
z
User Name:
For domain users: up to 97 characters with the format of "user name@domain name" or
"domain name\user name"
(user name and domain name must be up to 32 and 64 single-byte characters, respectively)
For local users: up to 32 single-byte characters
z
Password: Up to 32 single-byte characters
Print
Configure print settings. When [On] is selected, you can configure the settings for the Print
feature.
îš„Print Quantity
Set the number of copy sets from 1 to 999 in 1 set increments.
To Next Page
Loading...
Need help?
General
