1 Before Using the Machine
28
Before Using the Machine
1
5 Press the <TEST> button lightly with asharp
edge such as a pen tip. If the <RESET>
button pops up, it means thatthe ground
fault interrupter circuit isworking properly.
If not, the circuit is notworking properly.
6 Press the <RESET> button back to
thedepressed position.
If the circuit does not work properly,
contact your local Fuji Xerox representative.
<RESET>
button
<TEST> button
Do not attempt to remove a paper deeply jammed inside the product,
particularly a paper wrapped around the fusing unit or the heat roller.
Otherwise, it may cause injuries or burns. Switch off the product immediately
and contact your local Fuji Xerox representative.
Waste staples may come out with output paper. Be careful not to get injured
by the staples.
Never touch safety interlocks. When a front cover is open, safety interlocks
become activated to stop the machinery. Do not apply pressure on safety
interlocks with a coin or screwdriver. Otherwise, the machinery may become
activated and cause injuries.
Do not staple punched holes of paper. Sharp points of a staple may cause
injuries.
Never touch the paper output area of the finisher during operation. It may
cause injuries.
Be careful in removing jammed staples.
Ventilate well during extended operation or mass copying. It may affect the
office air environment due to odor such as ozone in a poorly ventilated room.
Provide proper ventilation to ensure the comfortable and safe environment.
Do not apply excessive force to hold thick document on the document glass.
It may break the glass and cause injuries.
To move this product to another location, contact your local Fuji Xerox
representative.
To Next Page
Loading...
Need help?
General
