Cleaning the Machine
107
Maintenance
3
Cleaning the Machine
This section describes how to clean the machine such as the machine exterior, document
cover, document feeder, and document glass.
Cleaning the Exterior
The following describes how to clean the exterior of the machine.
z
Do not use benzene, paint thinner, or other volatile liquids or spray insect repellent on the machine as they
might discolor, deform, or crack covers.
z
Cleaning the machine with an excessive amount of water may cause the machine to malfunction or damage
documents during copying.
1
Wipe the exterior with a firmly wrung soft cloth moistened with water.
z
Do not use cleaning agents other than water or neutral detergent.
z
If you cannot remove the dirt easily, gently wipe the machine with a soft cloth moistened with a small
amount of neutral detergent.
2
Wipe off any excess water with a soft cloth.
Cleaning the Interior (LED Printheads)
The following describes how to clean the interior (LED printheads) of the machine.
Normally, clean the LED printheads when you replace a drum cartridge and when you
replace the waste toner container. However, if you have image quality problems such as
white or colored stripes appearing on copied or printed outputs, clean the LED printheads.
When cleaning this product, use the designated cleaning materials exclusive to it.
Other cleaning materials may result in poor performance of the product. Never
use aerosol cleaners to avoid catching fire and explosion.
When cleaning this product, always switch off and unplug it. Access to a live
machine interior may cause electric shock.
To Next Page
Loading...
Need help?
General
