Installation When Using Internet Printing Protocol (IPP)
383
Printer Environment Settings
7
Installation When Using Internet Printing Protocol
(IPP)
This section describes how to install the machine using Internet Printing Protocol (IPP).
z
If the size of print data sent via IPP is larger than the value set in the proxy server, the machine cannot receive
the data. In this case, set a larger value in the proxy server or change your browser setting not to use the
proxy server.
Step 1 Preparations
The following items are required to set up the machine to use Internet Printing Protocol
(IPP).
z
TCP/IP network environment
z
Media (Software/Product Manual) provided with the machine
Step 2 Configuration on the Machine
The following describes the configuration procedures to use Internet Printing Protocol (IPP)
on the machine. Enable the IPP port, and then configure TCP/IP settings.
z
You can configure the settings using CentreWare Internet Services or the Media (Software/Product Manual).
z
For the items that can be configured using CentreWare Internet Services, refer to "CentreWare Internet Services Setting Items"
(P.384). For information on how to configure the setting using the Media (Software/Product Manual), refer to the Media
Information contained in the Media (Software/Product Manual).
1
Display the [Tools] screen.
1) Press the <Log In/Out> button.
2) Enter the system administrator’s user ID with the numeric keypad or the keyboard
displayed on the screen, and select [Enter].
When a passcode is required, select [Next] and enter the system administrator’s passcode,
and select [Enter].
z
The default user ID is "11111".
z
The default passcode is "x-admin".
3) Select [Tools] on the Services Home screen.
2
Enable the IPP port.
1) Select [Connectivity & Network Setup].
2) Select [Port Settings].
3) Select [IPP], and then select [Change Settings].
4) Select [Port Status], and then select [Change Settings].
5) Select [Enabled], and then select [Save].
To Next Page
Loading...
Need help?
General
