Paper and Other Media
60
Paper and Other Media
2
3
Push the tray in gently until it stops.
z
When pushing the paper tray in, do it slowly. If the tray is pushed with too much force, it may cause machine
malfunction.
Loading Paper in Tray 4 (When Tandem Tray Module is Installed)
The following describes the procedure for loading paper into Tray 4 when the Tandem Tray
Module is installed.
When the machine runs out of paper during copying or printing, a message is displayed on
the touch screen. Add paper according to the displayed instructions. Copying or printing
automatically resumes when paper is added.
z
Fan the paper well before loading paper in a tray. It prevents paper from sticking to each other and reduces
paper jams.
z
For information on changing the paper size and orientation, refer to "Changing the Paper Size for Tray 4 (When Tandem Tray
Module is Installed)" (P.68).
1
Pull out the tray until it stops.
z
While the machine is processing a job, do not pull out the tray that the job uses.
z
Do not add a new stack of paper on top of the remaining paper in the tray to prevent paper jams or any other
troubles. First, remove the remaining paper from the tray, and then load the new stack of paper.
z
Make sure to pull out the tray slowly. When the tray is being pulled out with
force, the tray may possibly hit your knees or other parts of your body causing
injuries.
To Next Page
Loading...
Need help?
General
