Fuji Xerox ApeosPort-VI C3370 Administrator's Guide

Appendix
814
Appendix
16
 Document: Auto, Coordinate Origin: 0 degrees, Scaling Mode: Paper Size, Scaling: On
Note
z
Change the factory default setting if required. For more information on changing procedures, refer to "HP-
GL/2 Emulation" (P.812).
Paper Margin
The paper size is set to A series paper by factory default. If the print data is larger than the
active coordinates area, the machine prints the data on the next larger A series paper (for
example, the next larger size of A4 is A3).
When you set the paper margins, however, the active coordinates area is determined by
subtracting the area set in paper margins from the active coordinates area obtained in the
area determination mode. Therefore, set the paper margins if the data is printed on larger
paper than specified. Set the range from 0 to 99 mm. The default value is 0 mm.
HP-GL/2 Emulation Settings
The following table shows the emulation parameters and their values for HP-GL/2
emulation.
HP-GL/2 Settings List
Items that can be set using the HP-GL/2 mode menu are explained in two groups: basic
settings and extended settings.
Document Size
Paper Size
Print Area

Fuji Xerox ApeosPort-VI C3370 Specifications

General

Print Resolution	1200 x 2400 dpi
Copy Resolution	600 x 600 dpi
Scan Resolution	600 x 600 dpi
Functions	Print, Copy, Scan, Fax (optional)
Fax Speed	33.6 kbps
Print Speed	33 ppm (black/color)
Connectivity	Ethernet, USB, Wi-Fi
Memory	4 GB
Paper Input Capacity	1, 140 sheets
Paper Output Capacity	250 sheets
Supported Paper Sizes	A3, A4, A5, B4, B5, Legal, Letter, Executive, Folio, Oficio
Duplex Printing	Yes
PDL	PCL6, PostScript 3
Copy Speed	33 ppm (color/black)