Tools
238
Tools
5
WebDAV
îš„ Port Status
Select [Enabled] when you use an application program such as Network Scanner Utility 3 to
access folders in the machine.
z
We recommend you to enable [HTTP - SSL / TLS Communication] under [SSL / TLS Settings] when you use
WebDAV. This is an effectual way to avoid password leaking.
z
You cannot select [Port Number] and [Operation Time-Out], if WebDAV port is disabled. To configure [Port
Number] and [Operation Time-Out], enable port status and reboot the machine, and then configure [Port
Number] and [Operation Time-Out].
îš„ Port Number
Enter a port number for WebDAV from 1 to 65535.
The default value is 80.
z
Do not use a number that is the same as a port number of another port. However, you can use the same port
number for a port that uses HTTP (IPP, Internet Services (HTTP), UPnP Discovery, SOAP, WebDAV, and Web
Services on Devices (WSD)).
îš„ Operation Time-Out
You can enter an operation time-out period between 1 and 65535 seconds in 1 second
increments.
ThinPrint
îš„ Port Status
You can use the machine for print in the ThinPrint
®
.print environment. The machine
decompresses and prints the compressed print data sent from the print server.
Select [Enabled] when you use ThinPrint.
îš„ Port Number
Enter a port number for ThinPrint from 1 to 65535.
The default value is 4000.
z
Do not use any numbers assigned to the other ports.
z
ThinPrint is available when the communication protocol uses IPv4.
z
The maximum of three connections are possible at a time.
Wireless LAN Settings
You can make the settings for the wireless LAN communication. For information on the
setting procedures, refer to "Wireless LAN Converter Setup Guide" accompanying the
Wireless LAN Converter.
To Next Page
Loading...
Need help?
General
