Fuji Xerox ApeosPort-VI C3370 Administrator's Guide

Problem Solving
706
Problem Solving
15
5 Pull up the metal part of the staple cartridge as shown in the illustration.
6 Remove the jammed staples (1), and then return the metal part pulled up in step 5 to the
original position (2).
7 With grasping the orange lever of the staple cartridge, push the staple cartridge into its
original position until it clicks into place.
8 Close the finisher front door.
Note
z
If the finisher front door is not completely closed, a message will appear and the machine remains paused.
If you cannot remove jammed staples even after you perform the above procedure,
contact our Customer Support Center.
Booklet Staple Jams in Booklet Staple Cartridge (for C3 Finisher with
Booklet Maker)
This section describes how to clear staple jam occurred in the booklet staple cartridge of the
C3 Finisher with Booklet Maker (optional).
CAUTION
Be careful in removing jammed staples.

Fuji Xerox ApeosPort-VI C3370 Specifications

General

Print Resolution	1200 x 2400 dpi
Copy Resolution	600 x 600 dpi
Scan Resolution	600 x 600 dpi
Functions	Print, Copy, Scan, Fax (optional)
Fax Speed	33.6 kbps
Print Speed	33 ppm (black/color)
Connectivity	Ethernet, USB, Wi-Fi
Memory	4 GB
Paper Input Capacity	1, 140 sheets
Paper Output Capacity	250 sheets
Supported Paper Sizes	A3, A4, A5, B4, B5, Legal, Letter, Executive, Folio, Oficio
Duplex Printing	Yes
PDL	PCL6, PostScript 3
Copy Speed	33 ppm (color/black)