Appendix
776
Appendix
16
Adjust Image Transfer
This section describes how to adjust the transfer output value.
You can specify the transfer output value manually or by scanning the sample printout.
This is useful when the toner image does not transfer to the paper properly.
Adjusting the Transfer Output Value
You can specify the image transfer output value for each paper type.
Adjusting the transfer output value manually
1
Press the <Log In/Out> button and enter the System Administration mode.
z
For how to enter the System Administration mode, refer to "System Settings Procedure" (P.156).
2
Select [Tools] on the Services Home screen.
3
Select [System Settings] > [Common Service Settings] > [Maintenance].
4
Select [Adjust Image Transfer].
5
Select [Paper Type].
To Next Page
Loading...
