Fuji Xerox ApeosPort-VI C3370 Administrator's Guide

Fold Position Adjustment
771
Appendix
16
6 Enter the values you measured in step 5 in [Values A & B Before Adjustment], and the value
to which to adjust in [Desired Values A & B].
Important
z
Set value A and value B so that an edge of the paper does not extend beyond a fold position of the paper.
Extending an edge of paper beyond a fold position of the paper may cause a paper jam.
7 Select [Adjust].
8 Select [Sample Printout] again.
9 Select the tray in which you loaded paper and press the <Start> button. The sample is
printed.
10 Select [Save].
11 Confirm the result of sample printout.
12 Adjust the alignment again if necessary. (Steps 5 to 11)
13 Select [Save].
14 Select [Close] until the Services Home screen is displayed.
Note
z
When you configure settings under [System Settings] or [Setup] and then press the <Services Home> button,
the screen directly goes back to the Services Home screen.
Z Fold Position Adjustment
Adjust the Z fold position.
1 Select [Z Fold - A4 ] or [Z Fold - 8.5x11" ], and then select [Change Settings].

Fuji Xerox ApeosPort-VI C3370 Specifications

General

Print Resolution	1200 x 2400 dpi
Copy Resolution	600 x 600 dpi
Scan Resolution	600 x 600 dpi
Functions	Print, Copy, Scan, Fax (optional)
Fax Speed	33.6 kbps
Print Speed	33 ppm (black/color)
Connectivity	Ethernet, USB, Wi-Fi
Memory	4 GB
Paper Input Capacity	1, 140 sheets
Paper Output Capacity	250 sheets
Supported Paper Sizes	A3, A4, A5, B4, B5, Legal, Letter, Executive, Folio, Oficio
Duplex Printing	Yes
PDL	PCL6, PostScript 3
Copy Speed	33 ppm (color/black)