Machine Information
145
Machine Status
4
Programming
You can check or change the value set for the print mode item number.
z
For the item numbers that can be configured in each mode menu, refer to "ESC/P-K Emulation Settings" (P.785), "PDF Direct Print
Settings" (P.801), "PCL Emulation Settings" (P.807), and "HP-GL/2 Emulation Settings" (P.814).
1
Select [Programming].
2
Enter the item number of the feature to set in [Item Number] with the numeric keypad.
3
Select [Confirm]. The current setting value appears.
4
Select [Change Value].
5
Enter [New Value] with the numeric keypad.
6
Select [Save].
Store/Delete Programming
For ESC/P-K and HP-GL/2 emulations, you can register settings in memory.
You can register up to 20 print modes for ESC/P-K and HP-GL/2 emulations.
1
Select [Store/Delete Programming].
2
Select [Store Current Selections] or [Delete].
îš„Store Current Selections
Stores the current selections. If you select a number already used, its settings will be
overwritten with the new settings. The overwritten settings cannot be restored.
To Next Page
Loading...
