Error Code
639
Problem Solving
15
033-700
[Cause] The connection is time out when a fax is send or the machine
receives a fax from a remote machine.
[Remedy] In sending a fax, execute the operation again. In receiving a fax,
the remote machine may cancel sending. Check the situation of
the remote machine.
033-701
[Cause] The connection is time out. The possible causes are as follows.
z
The recipient is during a call.
z
The phone number is wrong.
z
The recipient is not a fax machine.
z
The line is not correctly connected.
[Remedy] Confirm the following:
z
The recipient is not during a call.
z
The phone number is correct.
z
The recipient is a fax machine.
z
The line is correctly connected.
When there is no problem, retry the operation.
033-710
[Cause] The document to be sent by polling was deleted.
[Remedy] Store the document again.
033-711
[Cause] The specified page does not exist, or has a problem.
[Remedy] Contact our Customer Support Center.
033-712
[Cause] Unable to process because of insufficient memory.
[Remedy] Delete unnecessary data.
033-713
[Cause] An error occurred during fax transmission.
[Remedy] Contact our Customer Support Center.
033-716
[Cause] The folder specified from the sender's machine does not exist.
[Remedy] Register the folder.
z
Refer to "Create Folder" (P.315).
033-717
[Cause] The folder passcode specified from the sender's machine is
incorrect. Or, the machine passcode for reception is incorrect.
[Remedy] Inform the correct information to the sender's machine.
033-718
[Cause] Fax or polling documents do not exist in the folder specified
from the sender's machine.
[Remedy] Store fax or polling documents into the folder as necessary.
033-719
[Cause] The document may be deleted by turning the machine off and
then on.
[Remedy] Retry sending.
033-721
[Cause] An error occurred during fax transmission.
[Remedy] Switch off the machine power, make sure that the touch screen
is blank, and then switch on the machine power. If the error still
is not resolved, contact our Customer Support Center.
033-724
[Cause] The reception was interrupted because the image volume
exceeded the upper limit.
[Remedy] Install the Extension System Memory to increase the maximum
volume of image data.
Error Code
Cause and Remedy
To Next Page
Loading...
Need help?
General
