Error Code
173
Problem Solving
11
Error code (X-X)
Error Code Cause Remedy
Documents jammed in the document
feeder.
Remove the jammed document.
Refer to "Document Jams" (P.184).
The size of documents that are
loaded in the document feeder is not
supported.
Place the document on the
document glass.
Refer to "Document Jams" (P.184).
If a document is jammed, remove
the jammed paper.
Refer to "Document Jams" (P.184).
The document size cannot be
detected.
Check the followings:
- Only documents are placed on the
document feeder.
- The document guides are aligned
to the document.
- All documents are the same size.
The mixed size documents cannot
be loaded at the same time. If
containing different sizes, use the
document glass.
To continue the processing job,
reload the documents that have not
been copied or scanned yet, and
then press the <Start> button.
Refer to "Placing the Document" (P.84).
The document feeder cover is open. Close the cover.
Refer to "Machine Components" (P.48).
Either there is no tray to auto-select
or no appropriate size of paper
loaded in the selected tray.
First, select the desired tray from the
trays with lit indicators by pressing
the <Paper Supply> button and pull
out the selected tray.
Next, load paper that is the same
size and orientation displayed in the
paper size display area of the status
machine diagram, and then press
the <Start> button.
To cancel a job, press the <Stop>
button.
Refer to "Loading Paper" (P.75).
Out of paper in Tray 1. Reload paper in Tray 1. If the tray is
empty, load paper.
Refer to "Loading Paper in Trays 1 and
2 (Optional)" (P.75).
Out of paper in Tray 2. Reload paper in Tray 2. If the tray is
empty, load paper.
Refer to "Loading Paper in Trays 1 and
2 (Optional)" (P.75).
Out of paper in the Bypass tray. Reload paper in the Bypass tray. If
the tray is empty, load paper.
Refer to "Loading Paper in Bypass
Tray" (P.76).
To Next Page
Loading...
Need help?
General
