4 Loading Paper
78
Loading Paper
4
Changing Paper Size
This section describes how to change paper size in Trays 1 and 2.
Important • Do not load mixed paper sizes into a tray.
Note • When you change the size and orientation of paper in a tray, change the paper size setting
to match the paper size. For more information on how to change the paper size and
orientation settings, refer to "Setting the Paper Size" (P.80).
Changing the Paper Size for Trays 1 and 2
The following describes the procedure for changing paper size in Trays 1 and 2.
1 Pull out the tray until it stops.
Important • While the machine is copying or printing, do
not pull out the tray that the job uses.
• To prevent paper jams or loading errors, do
not load different sizes or types of paper on
top of any remaining paper in a tray.
2 Remove any paper loaded in the tray.
3 For Tray 1, push down the metal plate to the
bottom of the tray.
4 While pinching the two paper guide levers,
move them to the edges of the paper.
5 Load the paper with the side to copy or print
on facing up. Align the leading edge of the
paper with the left side of the tray.
Important • Do not load paper above the maximum fill
line. It might cause paper jams or machine
malfunctions.
To Next Page
Loading...
Need help?
General
