Using CentreWare Internet Services
43
Environment Settings
2
- Source IP Mask:
You can set the prefix length of the IP address that is allowed from access.
(Default: 0)
z
Edit button
The Edit IP Filter Rule - IPv6 screen is displayed. Edits the IPv6 address that is
allowed from access.
- Source IP Address:
You can set the IP address that is allowed from access.
- Source IP Mask:
You can set the prefix length of the IP address that is allowed from access.
(Default: 0)
z
Delete button
You can delete the IPv6 address that is allowed from access by pressing this
button.
Apply button
You can apply changes by pressing this button.
Note • Reboot machine to enable new settings.
System Administrator Settings (Security)
You can set the system administrator's user ID and passcode.
System Administrator Settings
z
Administrator's Login ID
You can enter the system administrator's user ID (between 1 and 32 ASCII code
characters in length, excludes "+", ";", "<", ">", """, "?", "[", "]", "'", "{", "}", "|", ":".
(Default: 11111)
z
Administrator's Passcode
You can set the system administrator's passcode (between 4 and 12 ASCII code
characters or blank). (Default: x-admin)
z
Retype Administrator's Passcode
You need to re-enter the system administrator’s passcode that you have entered.
z
Maximum Login Attempts
When login attempts using the system administrator’s user ID fail repeatedly,
access is denied when the number of failed attempts reaches the number set here.
Specify a number between 0 and 10. Specify 0 to disable this setting.
The total number of failed authentication attempts is reset when authentication is
successful or the system is restarted. (Default: 5)
Apply button
You can apply changes by pressing this button.
To Next Page
Loading...
Need help?
General
