6 Troubleshooting
142
Troubleshooting
6
Stapler Faults
This section describes how to clear stapler troubles when the optional finisher is installed.
Perform the procedures on the following pages when copies are not stapled or staples are
bent. Contact our Customer Support Center if the problem persists after you have tried the
following solutions.
Important • Even if the sheets have been stapled together properly, staples may rise up depending on the way
you handle the sheets.
If copies are stapled as shown in the figures below, contact our Customer Support Center.
One side of staple rising up Staple bent in reverse direction
Flattened staple Entire staple rising up
Staple rising up with center
pressed in
To Next Page
Loading...
Need help?
General
