Replacing the Staple Cartridge
95
Maintenance
5
4
Pinch both sides of the empty staple case with
your fingers (1), and remove the staple case
from the cartridge (2).
5
Insert the front side of the new staple case into
the staple cartridge (1), and then push the rear
side into the cartridge (2).
6
Push the staple cartridge into the finisher until it
clicks into place.
7
Close the finisher front cover.
Note • If the front cover is not closed completely, a message appears and the machine will remain paused.
Replacing Staple Cartridge (for Finisher B1)
When the Finisher B1 (optional) is installed and the staple cartridge needs to be replaced, a
message appears on the touch screen. When this message appears, load a new staple case
into the staple cartridge.
Important • The use of staple cartridges not recommended by Fuji Xerox may degrade quality and performance.
Use only staple cartridges recommended by Fuji Xerox.
• When the machine is in Power Saver mode, exit Power Saver mode by pressing the <Power Server>
button on the control panel before you replace the staple cartridge.
• When replacing the staple cartridge, press the <Machine Status> button and check the current
status for the staple cartridge even when the control panel is lit.
Note • To order a staple cartridge, contact our Customer Support Center.
1
Make sure that the machine is not operating,
and open the finisher front cover.
To Next Page
Loading...
Need help?
General
