5 Maintenance
94
Maintenance
5
Replacing the Staple Cartridge
Replacing Staple Cartridge (for Finisher A2)
When the Finisher A2 (optional) is installed and the staple cartridge needs to be replaced, a
message appears on the touch screen. When this message appears, load a new staple case
into the staple cartridge.
Important • The use of staple cartridges not recommended by Fuji Xerox may degrade quality and performance.
Use only staple cartridges recommended by Fuji Xerox.
• When the machine is in the Power Saver mode, exit the Power Saver mode by pressing the <Power
Saver> button on the control panel before you replace the staple cartridge.
• When replacing the staple cartridge, press the <Machine Status> button and check the current
status for the staple cartridge even when the control panel is lit.
Note • If the staple cartridge was not replaced properly, the message remains on the touch screen. Follow
the procedure and replace the staple cartridge again.
• To order a staple cartridge, contact our Customer Support Center.
1
Make sure that the machine is not operating,
and gently open the finisher front cover.
2
Take the staple cartridge out of the finisher.
Note • The staple cartridge is firmly inserted. A slight
force is required to pull the cartridge out of
the finisher.
3
After you take out the staple cartridge, check
inside of the finisher for any remaining staples.
Remove any staples remaining inside.
Message Solution
The Staple Cartridge is running out of staples.
Check the Staple Cartridge and order staples.
Prepare new staples.
Note • Staples cannot be replaced yet.
The Staple Cartridge is out of staples or not fully
inserted. Check the Staple Cartridge.
Replace staples with new ones.
To Next Page
Loading...
Need help?
General
