Safety Notes
21
Before Using the Machine
1
(6) Press the <TEST> button lightly
with a sharp edge such as a pen
tip. The depressed <RESET>
button will stick out again. This is
the end of the check procedure.
Note
• ApeosPort-VI C7771/C6671 and
DocuCentre-VI C7771/C6671 are equipped
with two <TEST> buttons.
(7) Press the <RESET> button back to the depressed position.
If the circuit does not work properly, contact Fuji Xerox Customer Support
Center.
Do not attempt to remove a paper deeply jammed inside the product,
particularly a paper wrapped around the fusing unit or the heat roller.
Otherwise, it may cause injuries or burns. Switch off the product immediately
and contact Fuji Xerox Customer Support Center.
Never touch the paper output area of the finisher during operation. It may
cause injuries.
Be careful in removing jammed staples.
Waste staples may come out with output paper. Be careful not to get injured
by the staples.
Never touch safety interlocks. When a front cover is open, safety interlocks
become activated to stop the machinery. Do not apply pressure on safety
interlocks with a coin or screwdriver. Otherwise, the machinery may become
activated and cause injuries.
Ventilate well during extended operation or mass copying. It may affect the
office air environment due to odor such as ozone in a poorly ventilated room.
Provide proper ventilation to ensure the comfortable and safe environment.
Do not staple punched holes of paper. Sharp points of a staple may cause
injuries.
Do not apply excessive force to hold thick document on the document glass.
It may break the glass and cause injuries.
To move this product to another location, contact Fuji Xerox Customer
Support Center.
When you use earphones, adjust the volume. Loud sound may cause hearing
loss.
(ApeosPort-ⅥC7771/C6671,
DocuCentre-ⅥC7771/C6671
Only）
<TEST>button
<TEST>button
To Next Page
Loading...
Need help?
General
