240 7 Maintenance
8. Fully close cover A.
9. Switch on the power of the printer by
pressing the <|> side of the power switch.
Output is too light
If printing is continued even after the message "Replace the print cartridge" is displayed, the
toner may run out during printing, resulting in output that is too light.
In this case, shake the cartridge with the procedure described below. This may allow you to
continue printing until the toner runs out completely.
Important
• Toner can easily spill out from the print cartridge. Before placing the removed drummer/toner cartridge
on the floor or a table, place a few sheets of paper to catch any toner that may spill.
• Do not shake or bump the removed print cartridge, as this may cause toner to spill out.
1. Switch off the power of the printer by
pressing the< > side of the power switch.
2. If there is paper in the center tray, remove it
before opening cover A.
Important
• Do not touch the parts inside the printer.
3. Grasping the print cartridge by its handle,
slowly lift it off the printer.
To Next Page
Loading...
