System expansions
Installing an accessible drive
► Open the casing (see "Opening the casing", Page 35).
► Break out the pre-cut plastic c over on the drive bay.
► Fit the drive cover for the 5
1
/
4
inch drive (see "Fitting the drive cover for
the 5
1
/
4
inch drive", Page 45).
1
► Slide the accessible drive into the casing until it snaps in place (1).
► Connect the cables to the drive. Make sure the polarity is correct.
► Close the casing (see "
Closing the casing", Page 36).
It may be necessary to modify the entry for the drive in the BIOS Setup.
46 Fujitsu
To Next Page
Loading...
