System expansio ns
► Pull the EasyChange rails off the hard disk drive.
► If you no longer need the EasyChange rails, secure them again at their location in the drive cage.
► C l o se t h e drive cage (see "
Close the drive cage", Page 41).
If necessary, you must adjust the entry for the drive accordingly in the BIOS setup.
Installing a hard disk drive
In the cold-plug process, the cables in the casing for the drive automatically lock
into place when the EasyChange rails are activated, as described below.
► Open the dr
ive cage (see "
Open the drive cage", Page 38).
Fujitsu 63
To Next Page
Loading...
