Fujitsu CELSIUS W570power - Removing the Hard Disk Drive; Inches or a Solid State Disc (SSD))

System expansions
Removing the hard disk drive (size: 2
1
/
2
inches
oraSolidStateDisc(SSD))
► Open the casing (see "Opening the casing", Page 35).
► FUJIT S U Workstation CELSIUS
W570power+ / W580power+: Open the drive
cage (see "
Open the drive cage
", Page 38) and pull it out of the casing (see
"
Pull the drive cage out of th
e casing.", Page 39).
► Disconnect the cables connected to the hard disk drive.
► Place the device on its si
de as shown below.
1
1
2
► Press the EasyChange rails slightly togethe r (1).
► Pull the hard disk drive out of the drive cage in the direction of the arrow (2).
► Pull the EasyChange rails off t he hard disk drive.
► If you no longer need the EasyChange rails, secure them again at their location in the drive cage.
► FUJIT S U Workstation CELSIUS W570power+ / W580power+: Reinsert the drive
cage into the casing (see "
Slide the drive cage into the housing.", Page 40) and
close the drive cage (see "
Close the drive cage", Page 41).
► Close the casing (see "
Closing the casing", Page 36).
► Position the d evice vertically again.
If necessary, you must adjust the entry for the drive accordingly in the BIOS setup.
60 Fujitsu