Fujitsu CELSIUS W570power - Install a Hard Disk, Size 2; Inches or a Solid State Disk (SSD)

System expansio ns
Install a hard disk, size 2
1
/
2
inches or a Solid State Disk (SSD)
EasyChange rails for the hard disk drive are located on the drive cage.
► Open the casing (see "
Opening the casing" , Page 35).
► FUJ ITSU Workstation CELSIUS W570pow er+ / W580p ow er+: Open the drive
cage (see "
Open the drive cage", Page 38) and pull it out of the casing (see
"
Pull the drive cage out of t he casing.", Pa ge 39).
► Place the device on its side as shown below.
1
1
2
► Secu re the EasyChange rails on the side of the hard disk (1) by inserting the uppe r pins
of the EasyChange rail into the corresponding h oles of the hard disk.
► Slide the hard disk drive with the EasyChange rails into the drive cage in the direction
of the arrow (2), until the hard disk is locke d in place.
► Connect the cables to the hard disk drive .
► FUJ ITSU Workstation CELSIUS W570power+ / W580power+: Reinsert the drive
cage i n to the casing (see "
Slide the drive cage into the housing.", Page 40) and
close the drive cage (see "
Close the drive cage", Page 41).
► C lose the casing (see "
Closing the casing", Page 36).
► Position the device vertically again.
If necessary, you must adjust the entry for the drive accordingly in the BIOS setup.
Fujitsu 61