System expansio ns
Installing and removing an M.2 m
odule
Installing an M.2 m odule
► Open the casing (see "Opening the casing", Page 35).
► If necessary, remove the front fan and long component groups for easier installation (see
"
Removing and fitting the front fan", Page 69 an d "R emoving a board", Page 73).
b
a
1
2
► Insert the M.2 module (b) at a slight angle in the direction of the arrow
(1) into the slot (a) on the mainboard.
► Secu re the M.2 module on the mainboard w ith the screw (2).
► If you have removed the front fan and long component groups: Refit these components (see
"
Removing and fitting the front fan", Page 69 and "Installin g a board", Page 71).
► C lose the casing (see "
Closing the casing", Page 36).
If necessary, you must adjust the entry for the drive accordingly in the BIOS Setup.
Fujitsu 75
To Next Page
Loading...
