Fujitsu CELSIUS W570power - Removing and Installing 2; Inch Hard Disks in the Drive Cage; Desktop CELSIUS W570 Power+, with both Installation Kits); Installing the Hard Disk Drive

System expansio ns
Removing and installing 2
1
/
2
inch hard disks in the
drive cage (only for the model
FUJITSU Desktop
CELSIUS W570power+, with both installation kits)
The procedure for installat
ionkit1(fortheinstallationvariantwithuptotwo2
1
/
2
inch
drives, vertical) is ident
ical to that of installation kit 2 (up to four 2
1
/
2
inch drives,vertical)
The device variant with i
nstallation kit 2 and four drives is shown below.
Installing the hard dis
kdrive
In the cold-plug process, the cables in the casing for the drive automatically lock
into place when the EasyChange rails are activated, as described below.
► Open the d rive cage (see "
Open the drive cage", Page 38).
a
► Secu re the EasyChange rails to the side of the hard disk drive by inserting the upper pins
of the EasyChange rail into the c orresponding holes of the hard disk. T he connections
(a) point to the rear, the label on the drive points to the right.
Fujitsu 65