System expansions
a
► Secure the EasyChange rails to the side of th e hard disk drive by inserting the
upper pins of the Ea syChan ge rail into the corresponding holes of the hard
disk. Th e connections (a) face towards the rear.
1
2
2
► Slide the hard disk drive with the EasyChange rails into the drive cage in the
direction of the arrow (1). Ensure that the connections of the hard disk drive
face inwards towards the inside of the casing.
► Press the levers of the EasyChange rails in the direction of the arrow (1).
► Close the drive cage (see "
Close the drive cage", Page 41).
If necessary, you must adjust the entry for the drive accordingly in the BIOS setup.
64 Fujitsu
To Next Page
Loading...
