Fujitsu CELSIUS W570power - Removing and Installing; Inch Hard Disks in the Drive Cage; Workstation CELSIUS W570 Power+ with Installation Kit 1 (Standard)); Removing the Hard Disk Drive

System expansions
Removing and installing 3
1
/
2
inch hard disks
in the drive cage (only for the
model F UJITSU
Workstation C ELSIUS W570 power+ with
installation kit 1 (standard))
If you have ordered a device with installation kit 1, you can replace
3
1
/
2
inch hard disks as de scribed below.
2
1
/
2
inch hard disks (vertical) are also installed with installation kit 1 (standard)
like the hard disks in the following sections with installation kit 2 ("
Removing and
installing 2
1
/
2
inch hard disks in the drive cage (only for the model FUJITSU
Deskto p CELSIUS W570power+, with both installation kits)", Page 65).
Removing the h ard disk drive
In the cold-plug process, the cables connected at the back of the drive will be
disconnected automatically when the EasyChange rails are activa ted, as described below.
► Open the drive cage (see "
Open the drive cage " , Page 38).
2
1
1
► Press th e brackets of the EasyChange rails on the hard disk drive in the direction of the
arrow (1) and pull the hard disk drive out of the drive cage in the direction of the arro w (2).
62 Fujitsu