System expansions
Removing an M.2 module
► Open the casing (see "Opening the casing", Page 35).
► If necessary, remove the front fan and long component groups for easier installation (see
"
Removing and fitting the front fan", Page 69 and " Removing a board", Page 73).
b
a
2
1
► Undo the screw (1).
► Pull the M.2 module (b) slightly at an angle in the direction of the arrow (2) and out
of the slot (a) on the m ainboa rd and remove it fro m the casing.
► If you have removed the front fan and long comp onent groups: Refit these components (see
"
Removing and fitt ing the front fan", Page 69 and "Installing a board", Page 71).
► Close the casing (see "
Closing the casing", Page 36).
If necessary, you must adjust the entry for the drive accordingly in the BIOS Setup.
76 Fujitsu
To Next Page