System expansions
Do not throw away the slot cover. For cooling, p rotection against fire and in order to
comply with EMC regulations, you must refit the slot cover if you remove the board.
a
1
2
► Push the board into the slot (1).
► Secure the module with the screw (2), if one is fitted.
► Fold the module lock (a) back down to close it.
► If necessary, connect th e cables to the board.
► For long modules: Install the front fan (see "
Removing and fitting the front fan", Page 69).
► Close the casing (see "
Closing the casing", Page 36).
If you have installed or removed a board, please check the relevant PCI
slot settings in the BIOS Setup. If necessary, change the settings. Further
information is provided in the PCI board documentation.
72 Fujitsu
To Next Page