Security Menu - Security features
SmartCard SystemLock/SystemLock 2 (optional)
SmartCard SystemLock
Item Specific Help SmartCard SystemLock Not Installed
Install Single PC:
[Enter]
Install Group PC: [Enter]
Installs the security
for this PC, and
creates a new
SystemLock Admin
SmartCard dedicated to
this PC.
SmartCard data will be
overwritten.
A correct SmartCard is
required for a
permanent installation
SmartCardSwitchingonthes
ystem
With Syste m Lock enabled, the PC can only be started using an initialised SmartCard (SICRYPT,
CardOS or Fujitsu) and a personal identification number (PIN). SmartCard and PIN are checked
by the B IO S during system boot , i.e. before the ope rating system is loade d.
All new SmartCards have a preset PIN (Personal Identification Number)
and PUK (Personal Unblocking Key).
On SICRYPT and CardOS Sma rtCards, PIN and PUK are prese t to 12345678.
On Fujitsu cards, the PIN is preset to 0000 and the PUK is preset to administrator.
We recommend that you change both PIN and PUK for security reasons.
Additional software (e.g. Smarty) is required in order to allow the system to also check
that the correct SmartCard is ins erte d when the system is running.
If BIOS-Setup does not list t he entry Sm artCard SystemLock in the Security menu, then your
system does no t support SystemLock. You can update your system BIO S using Flash BIOS
update (see Chapter "
BIOS update of USB stick or diskette", Page 63).
After you have initialised one SmartCard, it will not be possible to deactivate the
SmartCard SystemLock entry (Disabled)inBIOS Setup. P lease refer to "
Uninstall
SystemLock", Page 54 fo r how to uninstall SystemLock.
Fujitsu Technology Solutions 43
To Next Page
Loading...
Need help?
General
