Security Menu - Security features
Error messages
Errormessages
This chapter describes error messages generated by the mainboard.
SystemLock – Error messages
ErrormessagesSmartCar dreader
This chapter describes error messages generated by the SmartCard reader (chipcard reade r).
Boot access denied
The SmartCard has no access rights to the system.
Check your
SmartCard
The SmartCard is either inserted incorrectly or it is not a suitable SystemLock
SmartCard.
SmartCard reader
FAI LURE
An error has occurred on the serial po rt for the SmartCard reader (chipcard
reader). If this error occurs frequently, the conne ction between the SmartCard
reader and the mainboard must be checked , or the SmartCard reader must
be replaced. While the error is present, access to the system is blocked.
Non-authorised
SmartCard
The SmartCard cannot be used with this PC. The SmartCard has been
configured for a different PC.
SystemLock
installation
FAI LED:
An error occurred while installing SystemLock. D o not switch the PCC off,
but insert th e "Flash-BIOS diskette", execute a BIOS update and retry the
installation.
The SmartCard is
blocked.
Enter the PUK:
You have exceeded the maximum allowed number of incorrect PIN entries.
The SmartCard is blocked. Enter the administrator PUK to re-activate th e
SmartCard. You must then enter a new User PIN to restart the system.
TPM (Security Chip) Setting
Opens the sub
menu used to activate TPM and adjust TPM settings.
If this setu
p menu is available, then the m a inboard includes a security and encryption chip
(TPM – Trust
ed Platform Module) that co mplies with TCG Specification 1.2.
Similarly
to a SmartCard, this chip allows security-relevant data (passwords etc.) to be store d
securely.
The use of TPM is standardised and is specified by the Trusted Computing Group (TCG).
Security Chip
Activates/deactivates s upport for the Trusted Platform module.
Enabled
Trusted Platform Modu le support is activated.
Disabled
Trusted Platform sup port is deactivated.
Fujitsu Technology Solutions 55