Power M en u – Energy saving functions
Power Menu – Energy saving func
tions
Power
Item Specific Help
Power-on Source: [BIOS Controlled]
LAN:
[Enabled]
Wake Up Timer:
[Disabled]
Wake Up Time:
[00.00.00]
Wake Up Mode:
[Daily]
Power Failure Recovery: [Previous State]
[BIOS Controlled]
Power-on sources
are controlled by BIOS
Also valid for ACPI
operating systems.
[ACPI Controlled]
Power-om source are
controlled by an ACPI
operating system.
Wake On LAN boot:
[Boot Sequence]
Low Power Soft Off: [Disabled]
USB At Power-off: [Always Off]
USB Keyboard: [Disabled]
Hibernate like Soft Off: [Disabled]
Example showing t
he Power menu
Power On Source – Management of switch-on sources
Specifies whet her the switch-on sources for ACPI operating systems are managed
by the BIOS or the operating system.
BIOS
Controlled
The switch-on sources are managed by the BIOS.
ACPI Controlled
The switch-on sources are managed by the ACPI operating system.
Power On Source: LAN – Switch on via LAN controller
Systempower-on
Determines whether the system can be switche d on via a LAN controller (on
the mainboard or additional board).
Enabled The system can be switched on via a LAN con troller.
Disabled
The syste m cannot be switched on via a LAN controller.
Wake On LAN Boot – Switching on over the network
Switc
hons ystem
Specifies the system behaviour when switched on by means of network signals.
Boot
Sequence
The system boots up according to the device s equence specified in the Boot m enu
when switched on via LAN.
Force LAN
Boot
The system is booted remotely via LAN when switched on via LAN.
58 Fujitsu Technology Solutions
To Next Page
Loading...
Need help?
General
