4 Click the [Done] button.
The screen display returns to the [Drives] screen.
■
Dedicated Hot Spare Registration
The procedure to register a Dedicated Hot Spare is as follows:
1 Click the [Component] tab on the navigation of the ETERNUS Web GUI screen. On the [Component]
screen, click [Drives] in [Category].
The [Drives] screen appears.
2 Select the drive that is to be registered as the Dedicated Hot Spare and click [Assign Dedicated HS] in
[Action].
The [Assign Dedicated Hot Spare] screen appears.
3 Select the RAID group for the drive that was selected in Step 2
as the Dedicated Hot Spare. Click the
[Assign] button.
A confirmation screen appears.
4 Click the [OK] button.
The Dedicated Hot Spare is registered and the registration completion screen appears.
5 Click the [Done] button.
The screen display returns to the [Drives] screen.
Chapter 5 General Settings
5.7 RAID Configuration Settings
80
FUJITSU Storage ETERNUS DX60 S3 Disk storage system
Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
P3AM-9002-01ENZ0
To Next Page
Loading...
