Fujitsu M10 - Page 118

New
Reference: Old
Figure 3-36
Type-2 cable support
2.
Confirm that the rack is fixed in place to prevent the rack from toppling over.
For details, see "3.3.2 Securing the rack."
3.
Confirm the chassis mounting location in the rack. If necessary, mark the
location on the supporting columns.
The mounting locations have been predetermined for
the building block
configurations. See Figure 2-3 in "2.4.1 Mounting conditions for general racks."
4.
Step 4 differs depending on the shape of the supporting column holes of the
rack. Perform the work appropriate to the shape of the supporting column
holes of the rack.
For racks with supporting columns
having angled holes
Attach cage nuts to the left and right supporting columns of the rack.
- Attachment locations in the front supporting columns: (From the bottom) 1U
center, 2U bottom, and 3U top
- Attachment locations in the rear supporting columns: (From the bottom) 1U
center and 2U center
Fujitsu M10/SPARC M10 Systems Installation Guide
･
July 2015104