Fujitsu M10 User Manual

(*1) (*1)(*1)
600 mm
(23.6 in.)
700 mm
(27.6 in.)
600 mm
(23.6 in.)
800 mm
(31.5 in.)
1050 mm
(41.3 in.)
900 mm
(35.4 in.)
Rear service area
Rack
Front service area
(*2)
*1 This area is required on either the left or right side.
*2 To mount a chassis on the rack, an area with a depth of 1,200 mm (47.2 in.) is required in front of the rack.
If there is a possibility that a chassis will be added later, secure an
area with a depth of 1,200 mm (47.2 in.) in front
of the rack.
rack.
2.4.2 Installation area for a general rack
Service areas
Service area requirements vary depending on the rack used.
When using an expansion rack, see "2.4.4 Installation area for an expansion rack."
When mounting each chassis in the designated rack, see the examples of service areas
in Figure 2-5, Figure 2-7, and Figure 2-8. The rack width depends on
the rack used.
When using a rack other than the designated rack, see the manual for the rack used.
Figure 2-5
Example of service areas for the SPARC M10-1 (top view)
Fujitsu M10/SPARC M10 Systems Installation Guide
･
July 201528

Fujitsu M10 Specifications

General

Brand	Fujitsu
Model	M10
Category	Server
Language	English