Fujitsu M10 User Manual

XSCF>

showtelnet
Telnet

status:

disabled
XSCF>

settelnet

-c

enable
Continue?

[y|n]

:
y
XSCF>

showtelnet
Telnet

status:

enabled
XSCF>

showssh
SSH

status:

disabled

RSA

key:
7.3 Configuring the Telnet/SSH Service
To use the XSCF shell terminal and the control domain console of the specified
physical partition, use Telnet or SSH.
SSH and Telnet can be concurrently enabled. However, a Telnet connection is not
based on a secure connection protocol. We recommend disabling Telnet when SSH is
enabled.
7.3.1 Configuring the Telnet service
This section describes how to configure the Telnet service.
1.
Execute the showtelnet command to display the Telnet setting.
The following example displays the Telnet service setting. The factory default
setting is "disabled".
2.
Execute the settelnet command to configure the Telnet service.
The following example specifies that the Telnet service be enabled.
3.
Execute
the showtelnet command, and confirm that the Telnet setting is
"enabled".
7.3.2 Configuring the SSH service
1.
Execute the shows sh command to display the SSH settings.
The following example displays the SSH service settings. The factory default
setting is "disabled".
Fujitsu M10/SPARC M10 Systems Installation Guide
･
July 2015200

Fujitsu M10 Specifications

General

Brand	Fujitsu
Model	M10
Category	Server
Language	English