Fujitsu M10 - Chapter 8 Before Installing;Removing a System with a Building Block Configuration; 8.1 Confirming the System Configuration; 8.2 Confirming the Installation Pattern of a Building Block Configuration

Chapter 8
Before Installing/Removing a System
with a Building Block Configuration
This chapter describes the workflow for expanding or downscaling a system by
installing or removing, respectively, the SPARC M10-4S in a building block (BB)
configuration. The workflow varies depending on the system configuration. Be sure
to confirm the following before starting work:
■
Confirming the System Configuration
■
Confirming the Installation Pattern of a Building Block Configuration
■
Confirming the Removal Pattern of a Building Block Configuration
8.1 Confirming the System Configuration
Before installation/removal, confirm the pre- and post-installation/removal system
configurations. For details on system configurations, see the Fujitsu M10/SPARC M10
Systems Quick Guide.
8.2 Confirming the Installation Pattern of a
Building Block Configuration
This section describes the installation patterns of building block configurations and
the points of concern during installation.
8.2.1 Confirming the installation pattern
Figure 8-1 and Figure 8-2 show the installation patterns of building block configurations.
The necessary tasks vary depending on the installation pattern. Check which pattern
applies to your case. For details on system configurations, see the Fujitsu M10/SPARC
M10 Systems Quick Guide.
227