Fujitsu M10 - 10.3 Removal of Expansion Rack 2, and Decrease in the Number of SPARC M10-4 S Units to Four or Less

XSCF>

showbbstatus
BB#00

(Master)
Note -
If the serial number of the target chassis is being used as the system serial number, the
initbb command cannot release the chassis. In this case, execute the switchscf command to
switch the master XSCF.
XSCF>

poweroff

-y

-a
PPAR-IDs

to

power

off:00,01,02,03,04,05,06,07,08,09,10,11
Continue?

[y|n]:
y
00:Powering

off
01:Powering

off
02:Powering

off
03:Powering

off
04:Powering

off
05:Powering

off
06:Powering

off
07:Powering

off
08:Powering

off
09:Powering

off
10:Powering

off
11:Powering

off
10.3 Removal of Expansion Rack 2, and
Decrease in the Number of SPARC
M10-4S Units to Four or Less
This section describes the procedure to remove the expansion rack 2 and set four or
less SPARC M10-4S on the expansion rack 1 (connection via crossbar box). This
procedure corresponds to pattern C in Figure 8-3. You need to stop the system
during this work.
For details on the XSCF
commands executed in each step, see the Fujitsu M10/SPARC
M10 Systems XSCF Reference Manual.
1.
Log in to the master XSCF.
Execute the showbbstatus command to confirm that the XSCF to which you have
logged in is the master XSCF.
If it is a standby XSCF, retry to log in to the
master XSCF.
2.
Execute the show hardconf command, and confirm the chassis serial number
of the system board (PSB) targeted for release.
For details, see "A.2.1 Checking the component status."
3.
Execute the poweroff command to stop all the physical partitions.
Chapter 10 Removing a System with a Building Block Configuration 293